Diese Website verwendet Cookies. Durch die Nutzung dieser Website stimmen Sie der Verwendung von Cookies zu. Weitere Informationen finden Sie in unseren Datenschutzrichtlinie.

Die Bilder dienen nur als Referenz,

Siehe Technische Spezifikationen

DME1737-NW +BOM

I/O Controller Interface IC Super I/O

Hersteller:

MICROCHIP
Herstellerteil #:

DME1737-NW
Datenblatt:

DME1737-NW Datenblatt (PDF)
Part Life Cycle Code:

Obsolete
Reach Compliance Code:

compliant
EDA/CAD Modelle:

Fordern Sie kostenlose CAD-Modelle für an DME1737-NW

DME1737-NW Allgemeine Beschreibung

I/O Controller Interface 128-QFP (14x20)

Hauptmerkmale

General Features
— 3.3 Volt Operation (SIO Block is 5 Volt Tolerant)
— LPC Interface
— Programmable Wake-up Event Interface
— PC99, PC2001 Compliant
— ACPI 2.0 Compliant
— Multiplexed Command, Address and Data Bus
— Serial IRQ Interface Compatible with Serialized IRQ Support for PCI Systems
— PME Interface
— ISA Plug-and-Play Compatible Register Set
— 25 General Purpose Input/Output Pins
— System Management Interrupt
AC Power Failure Recovery
Watchdog Timer
2.88MB Super I/O Floppy Disk Controller
— Licensed CMOS 765B Floppy Disk Controller
— Software and Register Compatible with SMSC's Proprietary 82077AA Compatible Core
— Supports One Floppy Drive
— Configurable Open Drain/Push-PullOutput Drivers
— Supports Vertical Recording Format
— 16-Byte Data FIFO
— 100% IBM® Compatibility
— Detects All Overrun and Underrun Conditions
— Sophisticated Power Control Circuitry (PCC) Including Multiple Powerdown Modes for Reduced Power Consumption
— DMA Enable Logic
— Data Rate and Drive Control Registers
— 480 Address, Up to Eight IRQ and Three DMA Options
— Support 3 Mode FDD
Enhanced Digital Data Separator
— 2 Mbps, 1 Mbps, 500 Kbps, 300 Kbps, 250 Kbps Data Rates
— Programmable Precompensation Modes
Serial Ports
— Two Full Function Serial Ports
— High Speed NS16C550A Compatible UARTs with Send/Receive 16-Byte FIFOs
— Supports 230k and 460k Baud
— Programmable Baud Rate Generator
— Modem Control Circuitry
— 480 Address and 15 IRQ Options
Infrared Port
— Multiprotocol Infrared Interface
— IrDA 1.0 Compliant
— SHARP ASK IR
— 480 Addresses, Up to 15 IRQ
Multi-Mode™ Parallel Port with ChiProtect™
— Standard Mode IBM PC/XT®, PC/AT®, and PS/2™ Compatible Bi-directional Parallel Port
— Enhanced Parallel Port (EPP) Compatible - EPP 1.7 and EPP 1.9 (IEEE 1284 Compliant)
— IEEE 1284 Compliant Enhanced Capabilities Port (ECP)
— ChiProtect Circuitry for Protection
— 960 Address, Up to 15 IRQ and Three DMA Options
Keyboard Controller
— 8042 Software Compatible
— 8 Bit Microcomputer
— 2k Bytes of Program ROM
— 256 Bytes of Data RAM
— Four Open Drain Outputs Dedicated for Keyboard/Mouse Interface
— Asynchronous Access to Two Data Registers and One Status Register
— Supports Interrupt and Polling Access
— 8 Bit Counter Timer
— Port 92 Support
— Fast Gate A20 and KRESET Outputs
Motherboard GLUE Logic
— IDE Reset Output
— (4) Buffered PCI Reset Outputs with software controlled reset capability - default transparent
— 3VSB Gate and 3V Gate signal generation
— Front Panel Reset Debouncing and Power Good Signal Generation
— Power Supply Turn On Circuitry with Support for power button on PS/2 Keyboard
— Resume Reset Signal Generation
— SMBus Isolation Circuitry (2 sets external and 1 set internal for Hardware Monitoring Block)
— SMBus 2.0 compliant interface for Hardware Monitoring
— LED Control (2)
Fan Control
— 5 PWM (Pulse width Modulation) Outputs
— Low frequency and high frequency PWM support
— 6 Fan Tachometer Inputs
— Programmable automatic fan control based on temperature
— Interrupt Pin for out-of-limit Fantach Events
— Fantach events generate PME’s and/or Speaker warning
Temperature Monitor
— Monitoring of Two Remote Thermal Diodes
— Internal Ambient Temperature Measurement
— Limit Comparison of all Monitored Values
— Interrupt Pin for out-of-limit Temperature Indication
— Thermal events generate PME’s and/or Speaker warning
— Configurable offset for internal or external temperature channels

Spezifikationen

Part Life Cycle Code

Obsolete

Reach Compliance Code

compliant

Servicerichtlinien und andere

After-Sales- und Abwicklungsbezogen

Zahlung

Bezahlverfahren

TT/Überweisung

Paypal

Western Union

Geldgramm

Für alternative Zahlungskanäle kontaktieren Sie uns bitte unter:

[email protected]

Versand & Verpackung

Versandart

Fedex

UPS

DHL

NTN

Verpackung

AVAQ bestimmt und verpackt alle Geräte auf der Grundlage der Schutzanforderungen gegen elektrostatische Entladung (ESD) und Feuchtigkeitsempfindlichkeit (MSL)..